By A Mystery Man Writer
This is one that's had me stumped for a while. In another slicer (S3D), I can set the first layer to be different (hotter) than the following layers. For example, with PLA, I would usually do the first layer 5 C hotter, then on layer 2, reduce it. The Setting seems to point to something I just ca
Raft vs Brim vs Skirt: The Differences (incl. Cura settings)
The New Ultimaker 2+ Connect
Any advice for peeling first layer? : r/3Dprinting
Cura 4.6.1 - Printing temperature initial layer not working - UltiMaker Cura - UltiMaker Community of 3D Printing Experts
Prusa Slicer on Ultimaker - first layer problem – General discussion, announcements and releases – Prusa3D Forum
Ultimaker cura slices fine but on reading the gcode again through Cura, it shows a faulty 2nd layer [Screenshot attached]. Not sure if it is causing any real issue, but cannot find
Temperature tower - UltiMaker Cura - UltiMaker Community of 3D Printing Experts
Ultimaker Cura Now Available Page UltiMaker Cura UltiMaker , 40% OFF
10 Good Reasons to Use Cura
Best Ender 3 (V2,Pro) Cura Settings: Temperature, Speed, Retraction, More